Ring-communications DNA300 User Manual

DNA300 OPERATIONS MANUAL12006/06/13Ring Communications, Inc.Crisis Alert SystemI/O InterfaceDNA300

DNA300 OPERATIONS MANUAL102006/06/13The message format is in the following format for input messages to the DNA300:| STX | EVENT | RS | BUTTON ADDRESS

DNA300 OPERATIONS MANUAL112006/06/13CONFIGURATIONOne DNA100 is used as a programming interface to the DNA300. The DNA100 has one RS232port for connect

DNA300 OPERATIONS MANUAL122006/06/13ERROR HANDLINGMisspelled command input will give the following error message:Unknown CommandParameter errors will

DNA300 OPERATIONS MANUAL132006/06/13SERIAL PORTSet Parity, Data bits, Stop bits for serial port.PROGRAMMINGThe following commands are used for this fe

DNA300 OPERATIONS MANUAL142006/06/13CALL NUMBERSAll intercom stations are assigned call numbers in the Ring intercom central exchange.The DNA300 inter

DNA300 OPERATIONS MANUAL152006/06/13 Intercom Button NetSub Call Number Address Address============ ======== ======= 101 A1>

DNA300 OPERATIONS MANUAL162006/06/13BACKUPBackup generates all programming commands required to resetore the configuration of the DNA300.These command

DNA300 OPERATIONS MANUAL172006/06/13

DNA300 OPERATIONS MANUAL22006/06/13

DNA300 OPERATIONS MANUAL32006/06/13ContentsINTRODUCTION... 5INSTALLATION...

DNA300 OPERATIONS MANUAL42006/06/13

DNA300 OPERATIONS MANUAL52006/06/13INTRODUCTIONA serial RS232 device can be interfaced to the Crisis Alert Network for the purpose of handling incomin

DNA300 OPERATIONS MANUAL62006/06/13J1 - 8 pin (RJ45) Network connections :Two modular jacks are provided at the rear of the DNA300. Use modular cable

DNA300 OPERATIONS MANUAL72006/06/13J3 - 6 pin (RJ11) RS422 signals :A two twisted pair installation utilizing RS422 signals can be used to connect tw

DNA300 OPERATIONS MANUAL82006/06/13FRONT PANEL SWITCHES AND INDICATORS -SWITCHESSW1 - Reset. Creates a local reset for this node only.SW2 - Nod

DNA300 OPERATIONS MANUAL92006/06/13INPUT OUTPUT INTERFACESet the DIP switches so that SW3-7 is OFF and SW3-8 is OFF to activate the I/O software .COMM